Design Air Circulation

The rooms on the exterior of the building for ventilation air stream is used, while the can for the room that his position was in the middle of the building, a wind-catcher-channel, or channels bear called are usually when the wind catcher . So that the air flow naturally, openings are usually made on each of the two areas of the wall. The difference in air pressure inside and outside the building, the air flow from vents in the walls of the other fields vetilasi on another wall. The amount of air in each room should be sufficient to permit air circulation process air from outside into the fresh air ruangan.Bentuk usually uses a conventional window. Typically, window shutters made of glass or wood that is wide open in the day. Then there bouvenlicht window, which is a small window with two panes of glass, which is a gap between them that allowed for the exchange of air. Bouvenlicht mostly in halls, bathrooms or toilets.There are also types of window glass with glass louvers Nako, which can be opened and close.Selain can also take the form of the ventilation grille tactics horizontal wind can be placed on the wall. Varied ways to make a ventilation hole, start by made a hole in the wall, wood-frame grille with horizontal direction, or use the tap of concrete, metal, wood or aluminum. One good way is to design, natural ventilation is a cross ventilation system [cross-ventilation). On cross-ventilation is the air circulation system up so that air can flow from one point to point out other vents air vents set. With the pressure difference inside and outside the building, then the airflow is not in the house that led captive to the house feels stuffy and hot. If air is felt even less, then it may alternative ways exhaustfan namely by adding the active ventilation system is to the wall or the fan on the roof. Two of these tools is actively suck and drain the air being forced out of the room, to exchange with fresh air through the ventilation holes.